Skip to main content Skip to main navigation Skip to site search
Mounting systems:

A penetration-free flat roof mounting system

IBC Solar presents the latest iteration of its aerodynamic flat roof mounting system IBC AeroFix. The new AeroFix G3 can be well adapted to the respective module dimensions. The wide range of mounting options and the possibility to combine wide and narrow base rails make the system very flexible.

Ever-growing module sizes trigger the demand for mounting systems that are not only flexibly adaptable to the respective module type, but also guarantee maximum safety. The new AeroFix G3 can accommodate modules with lengths from 1500 to 2100 mm and widths from 980 to 1150 mm. Thanks to an integrated tilt joint in the AeroFix mounting support, the modules are aligned mechanically tension-free on the mounting system. This means that there is no tension in the module and the risk of cell damage and loss of performance is eliminated.

Time saving and convenient installation

In terms of installation choices, the new system offers a whole range of options that allow adaptation to any roof. The modules can be mounted either crosswise or upright on the AeroFix G3. With an elevation of 8, 10 or 15 degrees in a south or east-west direction, there are six different installation options.

See also: Changes to the management at IBC Solar AG

For maximum convenience and cost effectiveness, the AeroFix G3 mounting system features wide floor rails with pre-mounted construction protection mats and integrated cable ducts for up to 28 6 mm² cables. This not only facilitates installation, but also saves time, costs, and effort. In addition, the floor rails offer a large contact surface and thus ensure low surface pressure and even distribution of loads over the entire roof. (mfo)